The milled table is fully adjustable, rotational, tilt and swing and with the precision drilling system makes the whole equipment safe and sturdy to use. The 16mm keyed chuck is held in place by a taper drive shaft similar to the shafts used on industrial style pillar drills fitted with morse tapers. The vertical operation of the chuck is controlled by the three spindle side handle. Safety dictates that a transparent chuck guard is fitted and an adjustable depth gauge comes as standard.Power to the chuck is through the twin 9 speed taper pulley arrangement and power to this is from a 500w capacitor start induction run 230v electric motor. Drill speeds and corresponding pulley arrangements are shown on a chart fixed to the headstock. The top cover encloses the drive assembly and for safety a micro-switch cuts out the motor when the cover is opened. The industrial style no- volt release stop/start switch prevents the motor from starting up in the event of power failure protecting the operator. Drling Depth: 50mm Table Size: 170 x 170mm Table Tilting Range: 0° - 45° Base Size: 320 x 200mm Column Diameter: 46mm Distance Spindle/Column: 115mm Distance Spindle/Table: 270mm Distance Spindle/Base: 330mm Overall Height: 610mm. There will be additional charges to Northern Ireland, Southern Ireland, Scottish Highlands, includes below post code: PH/BT/IV/TR/IM/PA/KW/PO/AB/FK/HS/KA/ZE/GY/JE/BF, thanks.
This item is in the category "Home, Furniture & DIY\DIY Tools & Workshop Equipment\Power Tools\Corded Drills". The seller is "household-center" and is located in this country: GB.This item can be shipped to United Kingdom.